Unscrew the full syringe from the filling station, connect it with the adapter.ġ2. Connect the adapter with the catheter.ġ1. Put on gloves, lie down, apply the oil, insert catheter.ġ0. (If you decide to unscrew it, so park it close by upside UP. Do not unscrew the syringe from the filing station yet. When done, turn the valve of the filling station again to divert the flow of ozone into destructor. If the plunger doesn’t move, help it out by pulling on it gently. Turn the valve on the filling station to let the gas flow into the syringe. Make sure the ozone goes into the destructor of the filling station.Ħ. Allow the ozone generator to warm up for 10 to 15 seconds. Turn the valve so that the oxygen flows into the destructor, not the syringe.ĥ. Connect the syringe to the syringe filling station. Make sure the valve on the filling station is turned so that it does not block the oxygen flow.Ĥ. Let the oxygen flow before you turn on the ozone generator to flush all the lines. If it’s an oxygen concentrator: let the concentrator warm up for around 10 min, then adjust the regulator to 1/8 LPM. If it’s a tank: open the valve of the tank and the regulator at a low flow of 1/8 LPM. Have everything else close by: adapter, catheter, oil or cream, lubricated syringe, garbage bin, gloves.ģ. Prepare everything: put a towel on your couch, connect the oxygen source with the ozone generator, plug both into the power supply, connect the syringe filling station with the ozone generator. How to perform a rectal ozone insufflation with a syringeġ. I highly recommend the filling station though, because due to its attached destructor it minimizes the exposure to ozone in the air. Or simply attach the filter directly to the ozone out port on the Promolife and then fill the syringe through the port. You can also do without the filling station and simply use a piece of silicone tubing and a luer lock connector. I strongly recommend using the filter to prevent oil from the lubricated syringe from entering your generator. The one in the pictures above is the EliteO3 Dual Cell from Promolife. Any of the recommended generators on this page will do the job. It should be an oxygen fed generator which can produce ozone concentrations of at least up to 50 mcg/ml. Consult the chart of your ozone generator to find out whether you will be able to produce those concentrations. Whatever oxygen source you choose, make sure your ozone generator is able to produce concentrations between 20 and 50 mcg/ml at the given oxygen flow. Either an oxygen tank or an oxygen concentrator can be used which produces oxygen of at least 90% purity.
0 Comments
Leave a Reply. |